The AB30A200AC PWM servo drive is designed to drive brushless and brushed type DC motors at a high switching frequency. A single red/green LED indicates operating status. The drive is fully protected against over-voltage, under-voltage, over-current, overheating and short-circuits across motor, ground and power leads.
Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single AC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.
This drive can use quadrature encoder inputs, Hall Sensors, or a tachometer for velocity control.
Features
Manufacturer | Advanced Motion Controls |
---|---|
Product Category | Amplifiers - Analog Type |
Commutation | Trapezoidal |
Min Input Supply Voltage (VAC) | 30 |
Min Input Supply Voltage (VDC) | 40 |
Max Input Supply Voltage (VAC) | 125 |
Max Input Supply Voltage (VDC) | 175 |
Max Continuous Output Current (A) | 10 |
Max Peak Output Current (A) | 30 |
Motor System | Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless) |
Operating Mode | Current, Duty Cycle (Open Loop), Encoder Velocity, Hall Velocity, Tachometer Velocity |
Feedback | Hall Effect Sensors, Incremental Encoder, Tachometer |
Configuration | Panel Mount |
Drive Architecture | Analog |
Setup | Manual |
Min Operating Temperature (°C) | 0 |
Min Operating Temperature (°F) | 32 |
Max Operating Temperature (°C) | 65 |
Max Operating Temperature (°F) | 149 |
Max Rated Power (W) | 2494 |

Sample image only. Product may differ