The AB30A200I PWM servo drive is designed to drive brushless and brushed type DC motors at a high switching frequency. A single red/green LED indicates operating status.
The drive is fully protected against over-voltage, under-voltage, over-current, overheating and short-circuits across motor, ground and power leads. Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers.
The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes. This drive can use quadrature encoder inputs, Hall Sensors, or a tachometer for velocity control.
|Manufacturer||Advanced Motion Controls|
|Product Category||Amplifiers - Analog Type|
|Min Input Supply Voltage (VDC)||40.00|
|Max Input Supply Voltage (VDC)||175.00|
|Max Continuous Output Current (A)||15.00|
|Max Peak Output Current (A)||30.00|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Current, Duty Cycle (Open Loop), Encoder Velocity, Hall Velocity, Tachometer Velocity|
|Min Operating Temperature (°C)||0.00|
|Min Operating Temperature (°F)||32.00|
|Max Operating Temperature (°C)||65.00|
|Max Operating Temperature (°F)||149.00|
|Max Rated Power (W)||2494|
Sample image only. Product may differ