AVB200A100 servo amplifiers are designed to drive brushless DC motors at a high switching frequency for vehicle applications. It is fully protected against over-voltage, over-current, over-heating, under-voltage and short-circuits.
This model interfaces with digital controllers or can be used as a stand-alone drive and requires only a single unregulated DC power supply or battery. A single red/green LED and a single digital output indicate operating status. Loop gain, current limit, input gain, offset, command ramping, deadband can be adjusted using 14-turn potentiometers.
The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.It will accept tachometer input, quadrature encoder inputs, or Hall sensor inputs for velocity control.
|Manufacturer||Advanced Motion Controls|
|Min Input Supply Voltage (VDC)||20|
|Max Input Supply Voltage (VDC)||80|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Current, Duty Cycle, Hall Velocity, IR Compensation, Velocity, Voltage|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||75|
|Max Operating Temperature (°F)||167|
|Number of Axes||1|
|Max Rated Power (W)||9500|
|Max Continuous Output Current (A)||125|
|Max Peak Output Current (A)||200|
|Product Category||Motor Controllers for Electric Vehicles|
Sample image only. Product may differ