- Buy 5 for $451.00 each and save 3%
- Buy 10 for $456.00 each and save 2%
The STM17C-3CN integrated stepper is a drive+motor unit, fusing a NEMA 17 step motor and a sophisticated 2.0 A/phase (peak-of-sine) stepper drive into a single device. Power to the drive, located at the rear of the motor, must be supplied by an external DC supply.
The STM17C-3CN integrated stepper is designed to operate on a CANopen communication network and conforms to Can in Automation (CiA) DS301 and DSP402 specifications. It supports Profile Position, Profile Velocity, and Homing modes, as well as the ability to run stored Q programs via Applied Motion-specific CANopen objects. All STM17 units are setup and configured using Applied Motion’s ST Configurator™ software.
Each STM17 integrated stepper comes with 3 digital inputs, 1 digital output, and 1 analog input. The digital inputs accept signals of 5-24 VDC and can be used for connecting pulse & direction signals, end-of-travel limit switches, jog switches, quadrature encoder signals, PLC outputs, sensors, or many other signal types. The digital output can be connected to PLC inputs, counters, lights, relays, or other devices. The analog input accepts 0-5 VDC signals and can be used for velocity and position control.
The STM17C-3CN comes with an RS-232 port for programming and a CANopen port for network communications.
|Manufacturer||Applied Motion Products|
|Short Description||Drive + Motor + Control Unit (RS232, CANopen)|
|Max Holding Torque (mNm)||480|
|Max Holding Torque oz (in)||68|
|Max Length (mm)||107.5|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||85|
|Max Operating Temperature (°F)||185|
|Max Shaft Diameter (mm)||5|
|Max Shaft Diameter (in)||0.1969|
|Min Input Supply Voltage (VDC)||12|
|Max Input Supply Voltage (VDC)||48|
|Motor Construction||Hybrid Stepper|
|Motor Shape||Square Body|
|NEMA Frame Size||17|
|Number of Axes (Motors)||1|
|Rotor Inertia (kg-m-s²)||8.19E-06|
|Rotor Inertia (oz-in-s²)||1.16E-03|
|Series||STM Series,vendor=Applied Motion Products Inc.|
|Step Angle (°)||1.8|
|Product Category||Integrated Motors|
Sample image only. Product may differ