- Buy 5 for $301.00 each and save 3%
- Buy 10 for $304.00 each and save 2%
The STM17S-3AN integrated stepper is a drive+motor unit, fusing a NEMA 17 step motor and a sophisticated 2.0 A/phase (peak-of-sine) stepper drive into a single device. Power to the drive, located at the rear of the motor, must be supplied by an external DC supply.
The STM17S-3AN integrated stepper can operate in the following control modes: step (pulse) & direction, velocity (oscillator), and streaming serial commands (SCL). (STM17 integrated steppers do not support operation with the Applied Motion 4-axis and 8-axis SiNet Hubs).
All STM17 units are setup and configured using Applied Motion’s ST Configurator™ software.
Each STM17 integrated stepper comes with 3 digital inputs, 1 digital output, and 1 analog input. The digital inputs accept signals of 5-24 VDC and can be used for connecting pulse & direction signals, end-of-travel limit switches, jog switches, quadrature encoder signals, PLC outputs, sensors, or many other signal types. The digital output can be connected to PLC inputs, counters, lights, relays, or other devices. The analog input accepts 0-5 VDC signals and can be used for velocity and position control.
The STM17S-3AN comes with an RS-232 port for programming and serial communications.
|Manufacturer||Applied Motion Products|
|Short Description||Drive + Motor + Control Unit (RS232)|
|Max Holding Torque (mNm)||480|
|Max Holding Torque oz (in)||68|
|Max Length (mm)||107.5|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||85|
|Max Operating Temperature (°F)||185|
|Shaft Diameter (mm)||5|
|Shaft Diameter (in)||0.1969|
|Min Input Supply Voltage (VDC)||12|
|Max Input Supply Voltage (VDC)||48|
|Motor Construction||Hybrid Stepper|
|Motor Shape||Square Body|
|NEMA Frame Size||17|
|Number of Axes (Motors)||1|
|Operating Mode||Streaming Commands, Step & Direction, Velocity (Oscillator)|
|Rotor Inertia (kg-m-s²)||8.19E-06|
|Rotor Inertia (oz-in-s²)||1.16E-03|
|Series||STM Series,vendor=Applied Motion Products Inc.|
|Step Angle (°)||1.8|
|Product Category||Integrated Motors|
Sample image only. Product may differ