The B060A400AC PWM servo drive is designed to drive brushless DC motors at a high switching frequency. A single red/green LED and a single digital output indicate operating status. The drive is fully protected against over-voltage, under voltage, over -current, over-heating and short-circuits across motor, ground and power leads.
Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires a single unregulated AC or DC power supply and a nominal 24 VDC logic supply. Loop gain, current limit, input gain, offset, and ramp can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.
The drive accepts quadrature encoder inputs or Hall sensor inputs for velocity control.
|Manufacturer||Advanced Motion Controls|
|Product Category||Amplifiers - Analog Type|
|Min Input Supply Voltage (VAC)||200.00|
|Min Input Supply Voltage (VDC)||255.00|
|Max Input Supply Voltage (VAC)||240.00|
|Max Input Supply Voltage (VDC)||373.00|
|Max Continuous Output Current (A)||30.00|
|Max Peak Output Current (A)||60.00|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Current, Duty Cycle, Encoder Velocity, Hall Velocity, IR Comp, Tachometer, Voltage|
|Min Operating Temperature (°C)||0.00|
|Min Operating Temperature (°F)||32.00|
|Max Operating Temperature (°C)||75.00|
|Max Operating Temperature (°F)||167.00|
|Max Rated Power (W)||10630|
Sample image only. Product may differ