The store will not work correctly when cookies are disabled.
Please be aware we use cookies to make your experience better.A cookie is a piece of data stored on a visitor's hard drive to help us improve your access and identify repeat visitors. Cookies can also enable us to track and target the interests of our users to enhance the experience on our site. Usage of a cookie is in no way linked to any personally identifiable non-public information.Learn more.
A Step Motor is defined as a device whose normal shaft motion consists of discrete angular movements of essentially uniform magnitude when driven from a sequentially switched DC power supply.
A step motor is a digital input-output device. It is particularly well suited to the type of application where control signals appear as digital pulses rather than analog voltages. One digital pulse to a step motor drive or translator causes the motor to increment one precise angle of motion. As the digital pulses increase in frequency, the step movement changes into continuous rotation.
Types of Stepper Motors
There are three basic types of step motors in use, though in industrial automation the most common type is the hybrid type:
Active rotor: permanent magnet (PM)
Reactive rotor: variable reluctance (VR)
Combination of PM and VR: hybrid (HY)
Design Tips for Using Step Motors
Parallel connect the lead wires for best torque over the widest speed range
If not enough current is available from the drive, series connect the lead wires for full torque at low speeds
Keep motor case temperature below 100 °C. This can be achieved by lowering the motor current or limiting the duty cycle
Allow sufficient time to accelerate load
Use a microstepping drive for smoothest motor performance over a wide speed range
For open loop operation, size the motor with a 30-50% torque margin at speed. Including an encoder in the system and using a Stall Prevention feature may allow operation all the way down to a 0% torque margin
Do not disassemble motors. A significant reduction in motor performance will result
Do not machine shafts without consulting Electromate® first
Do not disconnect motor from drive while power is applied. Remove power from the drive before disconnecting the motor
Do not use holding torque/detent torque of motor as fail-safe brake
Use an Electromate® recommended stepper drive with your step motor to ensure optimal performance
Electromate sells a family of 2-phase hybrid type step motors with a 1.8° step angle in NEMA frame sizes from NEMA 8 to NEMA 42. Stepper motors from Electromate® are available in 4, 6 or 8 lead configurations for bipolar or unipolar operation. All motors can be wired in series or parallel, depending on the requirement. Motors are available with optional rear shaft extensions, encoders, brakes, cables, gearboxes and IP65 sealing.
Standard NEMA 34 dimensions. Two-phase hybrid step motor. High torque design. Integral 10 ft shielded cable w/ strain relief. Optimized for high bus voltage operation.
A cookie is a piece of data stored on a visitor's hard drive to help us improve your access and identify repeat visitors. We use necessary cookies to make our site work. We'd also like to set optional cookies to help us improve it. Usage of a cookie is in no way linked to any personally identifiable non-public information. Learn More.
By clicking “Accept”, you consent to the use of ALL the cookies. However you may visit Cookie Settings to provide a controlled consent.
